Page 1
MAGNETIC_1RwT MAGNETIC_5RwT www.sukcesgroup.pl In order to fully explore available functions of MAGNETIC series please take a moment and read this manual before using the device. MAGNETIC transmitters are compatible with all YOODA brand devices. 1. General information 1. Control: can control single motor, or a group of up to 20 motors on each channel 2.
Page 2
1. The programming button replaces the simultaneous pressing of the work mode button and L1 timer programming button. 2. Group channel is active when all numbers are selected 4. Estimated battery lifespan is 3 year if the device runs 4 commends a day in average. 5.
Page 3
6. Setting automatic opening and closing time 1. Difference between automatic time of roller shutter opening and closing cannot be shorter than 32 minutes. In case of smaller than minimal time difference fault message will appear. 2. Changes to opening and closing time can be done only in automatic mode. 3.
Page 4
7. Programming first transmitter to R-type motors 1. Way of programming first transmitter depends on type of radio receiver. When programming first transmitter please follow instruction of the device that is going to be controlled by the transmitter. 2. Longer than 5 seconds pause between series of button clicks during programming will cause device to switch off from programming mode without saving any changes.