Advertisement
Installing the Weights
Install the weights to the cutting unit as shown in
Figure
4.
1. Carriage bolts (5/16 x 1
inch)
2. Flange nuts (5/16 inch),
torque to 20 to 26 N∙m (15
to 19 ft-lb)
Installing the Roller-Brush
Assembly
1.
Remove the 2 flange locknuts securing each
roller bracket to the side plates, as well as any
6 mm (1/4 inch) spacers positioned on the
top side of the side-plate mounting flange
(Figure
3).
Note:
Do not remove the bolts. Keep the flange
locknuts for future assembly.
2.
Position the left or right roller-brush-assembly
mounting brackets onto the roller-bracket bolts
(Figure
5).
Figure 4
3. Weights
g283859
1. Left roller-brush assembly
Important:
for the roller-brush assembly directly to
the top surface of the side-plate mounting
flange of the cutting unit. Do not put spacers
between the roller-brush mounting brackets
and the side-plate mounting flanges. Save
the additional 6 mm (1/4 inch) spacers for
potential later use.
3.
Loosely secure the brush-assembly mounting
brackets to the cutting-unit side plates with the
previously removed nuts.
4.
Slide each excluder seal outward until the lip
seals are in light contact with each bearing
housing
(Figure
3
Figure 5
2. Roller-brush mounting
bracket
Attach the mounting brackets
6).
g035576
Advertisement
