Advertisement
Note:
Install the universal groomer kit first; refer to
the groomer installation instructions.
Important:
Use the Rear Roller Brush Kit only
when cutting in the height-of-cut range of 6 to
25 mm (1/4 to 1 inch). Use the high height-of-cut
brush when cutting above 25 mm (1 inch). Refer to
the procedure for Installing the High Height-of-Cut
Brush (Optional).
Note:
Determine the left and right sides of the cutting
unit from behind the cutting unit.
Determining the
Roller-Brush Orientation
Refer to
Figure 1
to determine the position of the roller
brush and reel motor.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
Note:
These instructions and illustrations show
the installation of the kit on cutting units with the
universal groomer mounted on the left end of the
cutting unit.
Figure 1
5. Cutting unit 5
6. Reel motor
7. Right roller-brush drive
assembly
8. Left roller-brush drive
assembly
Installing the Kit
Installing the Grease Fitting
1.
Remove the grease fitting for the roller from the
side of the cutting unit that has the roller-brush
housing
(Figure
1. Grease fitting
2.
Install the 90-degree grease fitting so that it
faces rearward
g027187
1. 6 mm (1/4 inch) spacer
2. Side-plate mounting flange 4. Flange locknuts (remove)
2
3).
Figure 2
(Figure
2).
Figure 3
3. 90-degree grease fitting
g032170
g032171
Advertisement
