Table of Contents Model CE-CN-WOK NG / Model CE-CN-WOK LP Model CE-CN-WOK16 NG / Model CE-CN-WOK16 LP Section Page General Information --------------------------------------------------------------------------- 3 - 4 Safety and Warranty --------------------------------------------------------------------------- 4 - 5 Technical Specifications -------------------------------------------------------------------------- 6 Installation --------------------------------------------------------------------------------------- 6 - 8...
If the package has suffered rough handling, bumps or damage (visible or concealed), please note it on the bill of lading before accepting the delivery and contact Omcan within 24 hours, so we may initiate a claim with the carrier. A detailed report on the extent of the damage caused to the machine must be filled out within three days, from the delivery date shown in the shipping documents.
Si el paquete ha sufrido un manejo de poco cuidado, golpes o daños (visible o oculto) por favor anote en la factura antes de aceptar la entrega y contacte Omcan dentro de las 24 horas, de modo que podamos iniciar una reclamación con la compañia.
Page 5
1 YEAR PARTS AND LABOUR BENCH WARRANTY Within the warranty period, contact Omcan Inc. at 1-800-465-0234 to schedule a drop off to either an Omcan authorized service depot in the area, or to an Omcan Service warehouse to repair the equipment.
Technical Specifications Model CE-CN-WOK NG CE-CN-WOK LP CE-CN-WOK16 NG CE-CN-WOK16 LP Burner BTU 95,000 125,000 Gas Type Natural Gas Liquid Propane Natural Gas Liquid Propane Number of Burners Pre-Heat Time 5 minutes Cooking Area 13” / 330mm diameter 16” / 406mm diameter...
Installation the flow of flue gases through and above the Wok range top grate. Position the Wok range in its final location. Check that there are sufficient clearances to service the Wok range and to make the required gas supply connection(s).
Installation • Prior to connecting the regulator, check the incoming line pressure, as these regulators can only withstand a maximum pressure of 1/2 psi (14” WC). If the line pressure is beyond this limit, a step down regulator will be required. •...
Operation INITIAL PILOT LIGHTING CAUTION: When lighting pilots and checking for leaks, do not stand with your face close to the combustion chamber. • All appliances are adjusted and tested before leaving the factory, effectively matching them to sea level conditions.
Maintenance DAILY MAINTENANCE BURNERS 1. Turn off range, remove all objects, and disconnect energy source. 2. Remove all top grates. 3. Lift off the burner heads by raising the head slightly, sliding to the rear or the range, and lifting upwards. 4.
Page 11
Troubleshooting Inconsistent burning. Insufficient gas pressure in pipe. Contact local gas supply department. Nozzle does not match gas Adjust nozzle diameter. requirements. Flow of connection pipe is not Increase pipe’s allowable flow. adequate. Damper opening degree is too Adjust damper. large.
Parts Breakdown Model CE-CN-WOK NG 47351 Model CE-CN-WOK LP 47685...
Page 13
Gas Valve with Handle for 47351 AI590 Reducing Elbow for 47351 AI575 Front Panel for 47351 AI583 Pilot Valve for 47351 AI591 Straight Pipe for 47351 Model CE-CN-WOK LP 47685 Item No. Description Position Item No. Description Position Item No.
Page 14
Parts Breakdown Model CE-CN-WOK16 NG 47686 Model CE-CN-WOK16 LP 47687...
Page 15
Parts Breakdown Model CE-CN-WOK16 NG 47686 Item No. Description Position Item No. Description Position Item No. Description Position AM908 Top Plate and Cylinder for 47686 AM914 Pipe Fix Plate for 47686 AI586 Duck Mouth Burner for 47686 AI569 Input Pipe for 47686 AM915 Support Beam for 47686 AM918...
Warranty Registration Thank you for purchasing an Omcan product. To register your warranty for this product, complete the information below, tear off the card at the perforation and then send to the address specified below. You can also register online by visiting: Merci d’avoir acheté...
Page 20
Since 1951 Omcan has grown to become a leading distributor of equipment and supplies to the North American food service industry. Our success over these many years can be attributed to our commitment to strengthen and develop new and existing relationships with our valued customers and manufacturers.
Need help?
Do you have a question about the CE-CN-WOK LP and is the answer not in the manual?
Questions and answers