Husqvarna TC 238TX Operator's Manual page 27

c) Carefully install the belt below around the
transmission cooling fan and onto the input
pulley (F). Make sure the belt is in the belt
keeper.
d) Install the belt on the centerspan idler (E).
e) Install the belt through the stationary idler (C)
and clutching idler (D).
f) Install the anti-rotation link (B) on the right
side of the product and tighten fully.
g) Connect the clutch harness (A).
h) Make sure the belt is in all pulley grooves and
in all belt guides and keepers.
i) Install the mower. See
the cutting deck on page 28
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove
the battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with
a wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
battery on page 14 .
To replace the battery
WARNING:
and burn injuries. Do not use metal
wristbands or other metal accessories.
Metal items that touch the battery
terminals can cause burn injuries,
electrical shock, and short circuit of the
battery.
1. Find the silver ground screw (A) on the right side
plate of the product, above the right rear tire.
D
B
A C
1962 - 001 - 23.09.2022
To remove and install
To connect the
Risk of electrical shock
2. Use a 1/2 in. (13 mm) wrench or socket to
remove the silver ground screw. Do not discard
the silver ground screw.
3. Pull the protective sleeve (B) away from the
terminal end (C) on the black (negative) battery
cable.
4. Use a 7/16 in. (11 mm) wrench or socket to
remove the larger red (positive) battery cable (D)
from the starter solenoid.
Note:
Do not remove the smaller red wire from
the wire harness on the solenoid valve.
5. From behind the product, open the battery door
(E) and remove the battery door support (F) from
battery door holders (G).
K
J
6. Put the battery door support in the slot (H) below
the battery door.
7. Pull the battery (I), with the 2 cables attached,
out of the battery compartment.
8. Put the battery on the battery door.
9. Disconnect the black (negative) battery cable (J),
remove the bolt and nut.
10. Disconnect the red (positive) battery cable (K),
remove the bolt and nut.
11. Carefully remove the battery from the product.
12. Install a new battery.
G
I
F
H
E
27