Advertisement
Installing the Grommets
1 Using the grease packet included in the kit, apply a thin film grease to the grommets and the section of the
transducer cable that feeds through the cable grommet
2 Place the cable grommet
3 Using the included grommet nut wrench
Installing the Propeller Drive Motor
Before you can install the propeller drive motor in the shaft, you must route the cables through the shaft
(Feeding the Cables Through the Shaft,
1 Using canned compressed air or an air compressor, blow out any dirt or debris in the six threaded holes on
the top of the propeller drive motor.
2 Gently feed the cables the rest of the way through the shaft.
When feeding the cables, you must pull on the cable and not on the cable connectors. Pulling the cable
connectors may damage the connectors.
3 Prepare the six bolts
NOTE: There are three different bolt lengths. Make sure the bolts are in the positions shown in the illustration
before tightening. The bolt length corresponds to the downshaft adapter height.
4 Using the grease packet included in the kit, apply grease to the 4.75 mm (
Avoid getting grease on the bolt threads.
12
over the transducer cable and slide it into the downshaft adapter
, tighten the grommet nut
page 10).
in the kit by placing a washer
.
.
NOTICE
and a 4.75 mm (
.
3
/
in.) O-ring
on each one.
16
3
/
in.) O-ring on each bolt.
16
Advertisement
