Advertisement
Figure 2. Static IP address assignment
7. Click Save (upper-right of the Configuration screen) to apply the settings.
8. When prompted, type the default username admin and the default password admin and click OK. The SD-WAN Edge 3400
attempts to reach the SD-WAN Gateway address, and the icon will turn green when successful.
NOTE:
Based on your service provider, a VLAN ID may be required.
Figure 3. GE5 shown with active WAN connectivity
NOTE:
SD-WAN Edge activation retains the static IP address settings when the activation profile has the corresponding
port configured as a routed port.
Set up PPPoE
To configure PPPoE, perform the following steps:
1. Connect through Ethernet or Wi-Fi and obtain a DHCP IP address from the SD-WAN Edge 3400.
NOTE:
In this example, GE1 is used.
2. Open a web browser and type
3. Click the Details button located below the image of the SD-WAN Edge 3400.
4. Click the name of the interface you want to configure for PPPoE, for example, GE3.
5. Under Configuration > Addressing, select the Static radio button, and enter the Username and Password.
http://192.168.2.1
in the address bar.
5
Advertisement
