Hob - Daily Use - Zanussi ZCG61246XA User Manual

Hob - Daily use

WARNING!
Refer to Safety chapters.
Ignition of the hob burner
Always light the burner before you
put on the cookware.
WARNING!
Be very careful when you use open
fire in the kitchen environment. The
manufacturer declines any
responsibility in case of the flame
misuse.
The spark generator can start
automatically when you switch on
the mains, after installation or a
power cut. It is normal.
In the absence of electricity you can
ignite the burner manually.
Ignition of a the hob burner without the
thermocouple
• For all hobs without thermocouple first turn
the knob and then push the knob down.
Release knob when the burner lights.
• For integrated ignition on knob push the
knob for the hob down and turn it
counterclockwise to the maximum gas flow
position .
Keep the knob for the hob pushed for equal or
less than 10 seconds to let the thermocouple
warm up. If not, the gas supply is interrupted.
Adjust the flame after it is regular.
WARNING!
Do not keep the knob pushed for
more than 15 seconds. If the burner
does not light after 15 seconds,
release the knob, turn it into the off
position and try to light the burner
again after minimum 1 minute.
If after some tries the burner does
not light, check if the crown and its
cap are in the correct position.
www.zanussi.com
If the burner accidentally goes out,
turn the knob to the off position and
try to light the burner again after
minimum 1 minute.
Burner overview
A. Burner cap
B. Burner crown
C. Ignition candle (if applicable)
A
B
C
A
B
C
9