Related Manuals for Walthers PROTO 2000 Series
Summary of Contents for Walthers PROTO 2000 Series
- Page 1 From Walthers RS27 Diesel with QSI Quantum System™ Sound & Train Control Operations Manual...
-
Page 2: Basic Analog Operation
Quantum operation. See thelist of suitable power packs intheQuantum Analog Reference Manual (Version 3)at www.walthers.com. Your diesel locomotive may not have all lights depending on themodel. Page 2... - Page 3 8). For recommended power packs, consult the Quantum Analog Reference Manual (Version available at www.walthers.com. Doppler Effect This effect changes the horn pitch and engine sounds as locomotive passes. • While the engine is moving toward the observer, flip the direction switch to turn on the horn.
- Page 4 Changing the Locomotive's Direction without Turning off the Sound You can use the power pack's direction switch while the locomotive is in neutral to change engine's direction. • Put the locomotive in neutral by bringing the throttle down below V-start wait for the locomotive to stop •...
- Page 5 DC output from the power pack and two wires go to the track. features on power pack remain the same including throttle and reverse switch control. See our site at www.walthers.com for further information. Page...
-
Page 6: Analog Programming
Analog Programming The Diesel Locomotive can be Programmed Using a Standard Power Pack. All advanced operations are easily programmed via your standard HO power pack. After entering programming (described below), features are selected and operated by using the direction switch. Option Program Name... - Page 7 Once you perform the three bell operations after applying power, the bell will shut off automatically and you will hear "Enter Programming" and the Headlight and Reverse Lights will flash alternately off and on. Scrolling through the Program Options • After entering programming, you will hear an announcement of the first Program...
- Page 8 V-Start and V-Max to prevent them from fighting each other. For more information, download the Quantum Analog Reference Manual (Version 3)from http://www.walthers.com DCC Operation These steps will allow you to start operating your diesel locomotive immediately using any qualified NMRA command station.
- Page 9 Function Keys The following table lists features that have been pre-assigned to your DCC function keys. Operation of these keys can be different in the neutral state (locomotive stopped) and motive states (locomotive moving in forward or reverse). After you have selected your locomotive, simply press any of the function keys listed below to produce the described effects.
- Page 10 Sound-of-Power™ Your diesel locomotive will produce labored diesel motor sounds under acceleration and lighter diesel motor sounds under deceleration but only if CV 3, or CV 23 and CV or CV 24 are set to non-zero positive values. The level of labored sounds is proportional to the values for these four CVs, and how much the throttle is increased or decreased.
- Page 11 Automatic Features with "Take Control" Operation The Quantum System allows the operator to take control of certain automatic features by using their associated function key. Once you "Take Control", the features will no longer have automatic operation and you will control their operation and their state with their function commands.
- Page 12 If power is turned off at any stage of Shut Down (Disconnect, Standby or Total Shut Down) or during a Shut Down procedure, the engine will remember the last Shut Down stage where it was during power down, and will power up in the same stage. If Start Up is initiated during any of the above Shut Down procedures, Shut Down is aborted and the engine returns to normal operation.
- Page 13 Dynamic Brakes on prototype locomotives lesseffective and seldom used lowspeeds. Page...
- Page 14 Function Key Operation in Neutral Some Function Keys used in Forward Reverse will have different effects in Neutral: • The F7 key produces Brake Squeal for a moving engine but produces a long let-off in neutral. • Pressing F6 results in Doppler shift for a moving engine activates...
- Page 15 Reset all CV's to Factory Default Values (CV 56.128.255) Note: This does not affect Analog settings, except volumes. • Set CV 49 to 128. • Set CV 50 to 255. • Set CV 56 to 113 InOps mode, you will hear 3 hoots when reset is completed. •...
-
Page 16: Quantum System Sounds
For more information, download the Quantum DCC Reference Manual (Version 3) from www.walthers.com. Quantum System Sounds Diesel Motor Rev: Quantum allows diesel motors to be operated with all eight notches corresponding to the throttle notches used on the prototype. As the throttle is turned the diesel motor RPM will increase in fixed increments until the maximum RPM occurs at notch 8. - Page 17 "OARC™orQuantum Analog Remote Control'Muses special signals under Analogcontrol operate different Quantum features.With OARC, youcanoperate features thatarecurrently available only in inaddition tofeatures that are not yet available in DCC. Page...
-
Page 18: Special Operation And Troubleshooting
For a full description, see Troubleshooting section in the Quantum DCC Reference Manual (Version 3) at www.walthers.com. With some command stations, using the horn button activate the horn, and, while this button is held down, activating the F6 Doppler Key,... - Page 19 locomotive now been returned to original factory defaults including all DCC and Analog values. Turn your Locomotive Off or On using the Magnetic Wand (Analog Only) Your locomotive can be selected (turned on) or deselected (turned off) using the Magnetic Wand. When the locomotive deselected,...
- Page 20 & Features Sounds Common to Analog & Analog Features* Features* System Volume Programming F0 or FL light control Horn or hoot F1-F12 Function Keys Bell with shut down and Individual Sound Volume 14/28/126 speed steps (28) turn on effects Control Coupler Sounds Diesel Motor Air Brakes...
- Page 21 Diesel Model Specifications for Life Like Model ALCo RS-27 Diesel Locomotive Engine Description: Quantum Software Version: H0137f32 Lighting: Light Options Included on this Model Comments Headlight Dimmable Mars Light Reverse Light Number Board Liahts Extended ID Numbers tor Individual Cab Numbers ID Table Engine CV 17...
- Page 22 OSImakes norepresentationsor warranties withrespect this publication. Inno event shall QSlndustries,Inc., be liable for any damages,direct incidental, arising out of or relatedto the use this publication. 8/04 QSlndustries,Inc. Beaverton,OR WALTHERS Page @2005 Walthers, Inc., 5601 Florist Avenue Milwaukee, 53218 RM585280...