Wireless Keypad - beamUP BU250 Product Manual

PROGRAMMING WIRELESS KEYPAD (BU850)
Look in the box for:
Wireless 2 x Lag Screws
keypad* #6 x 1-3/8"
WARNING
To prevent SERIOUS INJURY or DEATH:
• Keep remote control and battery out of reach of
children.
• Never permit children to access the door control or
remote control.
• Operate door ONLY when it is adjusted properly with
no obstructions to door travel and is in clear sight.
• ALWAYS keep a moving door in sight until
completely closed. NO ONE should cross the path
of a moving door.
To reduce risk of fire, explosion or electric shock:
• DO NOT short circuit, recharge, disassemble or
heat battery.
• Replace with 2 x AAA batteries ONLY. Dispose of
batteries properly.
*NOTE: If your model is provided with a Wireless Keypad, follow the programming instructions on this page.
1. Press and release the "Learn" button.
2. The "OK" LED will illuminate
indicating ready for programming.
2 x Anchors
3. Garage door opener is ready to accept
PIN within the next 30 seconds.
Beeps
30 sec
Erasing ALL remote controls from memory:
To erase ALL remote controls from memory, press
and hold "Learn" button for 3 seconds. "OK"
LED will flash and beep three times indicating all
remotes have been erased from memory.
2 x beeps
Enter your 2-6 digit PIN within
30 seconds and press the
ENTER
Press and release LEARN
Press and hold LEARN for 3 seconds
"OK" LED will flash and beep
twice indicating code is set.
button.
2 x flashes
30 sec
Wireless keypad may be secured on door jamb
outside your garage. Install keypad within sight
of door at minimum height of 5 feet (1.5 m). Test
the range of the keypad before mounting. Find an
alternative mounting location if range is insufficient.
beamlabs.io
2 x beeps
27
1-800-436-9186