Omron F150 Operation Manual page 60

Position Compensation
Adjust the binary level so that the area for which the center of
gravity and axis angle are to be calculated is white.
OK: The measurement object
is shown in white pixels.
If the measurement object must also be rotated to compensate
for rotation displacement, set models in both region 0 and region
1 and then set rotational position displacement compensation
using the angle between the models in the two regions.
Region 0
Reference position (X, Y)
52
1
Enter Set mode.
2
Move the cursor to Position compensation/Region/Set-
ting and press the ENT Key.
3
Move the cursor to either 0. or 1. and press the ENT Key.
Section
Wrong
→
p 64
Reference position
(angle)
Region 1
3-4