During Operation; Starting The Machine; Adjusting The Blade Speed - Toro 21611 Operator's Manual

During Operation

Starting the Machine

1. Ensure that the battery pack is charged and installed in the machine; refer to
(page 11).
2. Squeeze the blade-control bar and hold it to the handle (A of
3. Press the electric-start button and keep it pressed until the motor starts (B of

Adjusting the Blade Speed

This machine has 2 blade-speed settings: A
•
When set to the A
UTO
cutting conditions are detected and the blade speed increases when necessary to maintain quality of cut.
•
When set to the M
AX
Press the blade-speed button on the electric-start housing to adjust the blade speed setting
1. Blade-speed button
UTO
setting, the blade speed is adjusted automatically for greater efficiency; changes in
setting, the blade speed remains at the highest speed at all times.
Figure
Figure 9
and M .
AX
Figure 10
13
Installing the Battery Pack
9).
Figure 9).
(Figure
g409982
10).
g410773