Page 1
INSTRUCTION BOOKLET F Series Chimney Extractors IMPORTANT: You must read this instruction Book before installing or using this appliance and retain it for future use. Caple Products Telephone 0870 2411142 Facsimile 0117 982 6878 Page 1 of 7 F SERIES CHIMNEYS...
Thank you for buying your new CAPLE Chimney Extractor. To ensure that you get the best results from your new Chimney Extractor, we strongly suggest that you read this instruction manual thoroughly before use. This manual contains instal- lation advice, usage instructions and a cleaning guide, as well as other important facts about your CAPLE Chimney Extractor.
Page 3
Hood Description - Fig. 1 1. Control panel 2. Metal grease filter 3. Worktop illumination Use: Two systems are available Exhaust mode (Fig: S) Vapors are extracted outside through an exhausting pipe that is affixed to the connection ring above the hood. Diameter of the exhausting pipe must be equal to that of the connection ring.
INSTALLATION When installed, the distance between hood and gas burners or electric plates must be not less than 65 cm providing the total hob output does not exceed 11kw. For each kw in excess of 11kw the distance between extractor and gas hob must be increased by 10cm.
MAINTENANCE Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the connector and removing the connector fuse. Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.
Page 6
Replacing the lamp 1. Disconnect the hood from the electricity. 2. Remove the grease filters (Fig. 2). 3. Illumination: always replace burnt-out lamps with 40-Watt max. (E14) (Fig. 5) -20 Watt max. (Fig. 6) and 11-Watt max. (Fig. 7). 4. Refit the metal grease filters. 5.
CAPLE "Built-in" Service Should you require service at any time, please contact the Caple Help line on 0870 2411142. Caple have a nationwide service network of engineers who will respond quickly to your call. Always replace spare parts with genuine Caple spares. These are available from authorized Caple Service Centres or by mail order from our National Service Stores, simply telephone 0870 2411142.