Table of Contents
Advertisement
How do I get started?
Please refer to the following installation and
setup instructions. This will guide you, step by
step, through the installation and setup process.
What do I need?
To install the dimmer, you will need to remove
and replace the existing lightswitch. This is
usually straightforward, but you must ensure that
there is a suitably deep housing (backbox) and
understand how to safely turn o
supply. You will also need suitable electrical
screwdrivers.
Help video & further guidance
For additional guidance, and to watch a video
that will help guide you through the installation
process, please visit the support section on
www.lightwaverf.house
Get Started
the electricity
Advertisement
Table of Contents
Need help?
Do you have a question about the Connect Series and is the answer not in the manual?
Questions and answers