Zanussi ZBA 6154A Operating Instruction page 48

G G B B
5. Separate parts Ha, Hb, Hc, Hd as shown in the
figure.
6. Place guide (Ha) on the inside part of the furniture
door, up and down as shown in the figure and mark
the position of external holes. After having drilled
holes, fix the guide with the screws supplied.
7. Fix cover (Hc) on guide (Ha) until it clips into place.
48
8. Open the appliance door and the furniture door at
90°. Insert the small square (Hb) into guide (Ha). Put
together the appliance door and the furniture door
and mark the holes as indicated in the figure.
9. Remove the squares and mark a distance of 8 mm
from the outer edge of the door where the nail must
be fitted (K).
10. Place the small square on the guide again and fix it
with the screws supplied.
Should the alignment of the furniture door be
necessary, use the clearance of slots.
At the end of this procedure, it is necessary to
check if the door of the furniture closes properly.