Zanussi ZBA 6154A Operating Instruction page 47

It is necessary that the niche is provided with a conduct
of ventilation having the following dimensions:
Depth 50 mm
Width 540 mm
For appropriate venting, follow indications in the figure.
1. Fit the appliance in the niche by making sure that it
stands against the interior surface of the unit on the
side where the door hinges of the appliances are
fitted. Insert the appliance until the upper strip butts
up against the unit (1) and make sure that the lower
hinge is in line with the surface of the unit (2).
2. Open the door and push the appliance against the
side of kitchen furniture opposite to that of the
appliance hinges. Fasten the appliance with 4
screws (I) provided in the kit included with the
appliance.
3. Press in the joint covers between the appliance and
the kitchen
furniture.
4. From the plastic cover (E), which is used to cover the
hinge with the pivot pin, you must take away the part
as indicated in the drawing.
This operation is made easer since there is, in the
internal part of the cover hinge lid a groove that
facilates the removal of this coomponent.
"Remove the part marked with DX, if the pivot pin is
inserted in the right hinge, SX in opposite case."
Apply covers (C-D) on joint cover lugs and into hinge
holes. Snap hinge covers (E) into position.
G G B B
47