Cleaning; How To Change The Bulb - Zanussi ZBA 6154A Operating Instruction

G G B B
Occasionally check defrost water outlet not to be
clogged up.
The most typical case of clogging up in the defrost water
outlet when you put food wrapped in some paper into the
appliance and this paper contacts back plate of fresh
food compartment and freezes to it. If you remove the
food right at this moment the paper will tear and it can
cause clogging up in the outlet by getting into it. So you
are asked to be careful - because of the above - when
placing foods wrapped in paper into the appliance.
In case of increased demand e.g. during
heatwaves, the refrigerator temporarily happens to
operate constantly. During this the automatic defrosting is
ineffective.
Remaining small ice and frost stains on back plate of the
fresh food compartment after defrosting period is not
abnormal.
The frozen food compartment can not be equipped with
automatic defrosting set since the deep-frozen and
frozen foods do not endure melting temperature.
Provided it is not too thick, the layer of frost or ice can be
scraped off and removed using a plastic scraper.
When ice coating is so thick that it can not be removed
with the plastic scraper, the frozen food compartment
has to be defrosted (generally 2-3 times a year).
Take the foods out of the frozen and fresh food
compartment, wrap them into some layers of paper or
cloth. Put them to a possible cool place while defrosting.
Break the circuit of the appliance and leave the doors of
frozen and fresh food compartment open.
Continuously blot off the defrosting water by a soft cloth
or sponge.
After defrosting wipe the surfaces, apply voltage to the
appliance and put the foods back to their places.
It is recommended to operate the appliance at the
highest position of the thermostatic control so that it can
reach the proper storing temperature as soon as
possible.
42

Cleaning

Never use metal objects for cleaning your
appliance as it may get damaged.
NEVER use detergents, abrasive powders, highly
perfumed cleaning products or wax polishes to
clean the interior as these will damage the surface
and leave a strong odour.
Clean the inside with warm water and bicarbonate of
soda. Rinse and dry thoroughly.
To guarantee a safe operation of the fridge, once a year
remove the ventilation grill at the base and clean the air
channels with a vacuum cleaner.
When the appliance is not in use
Disconnect the appliance from the electricity supply.
Empty all foods and clean the appliance, leaving the
doors ajar to prevent unpleasant smells.

How to change the bulb

Should the light fail to work you can change it as below:
Break the circuit of the appliance.
Unscrew the plate screw fixing the lamp cover, then take
the lamp cover off in the direction of arrow and the bulb
can be changed. (Type of the bulb: Mignon 322, 230 V,
15 W, E 14 thread)
After changing bulb replace the lamp cover, screw the
plate screw and apply voltage to the appliance.
The lack of light does not influence operation of the
refrigerator.