Table of Contents
Advertisement
HOW TO USE THE TIMER
To program heating, proceed as follows (fig.7):
-
Look at the time on your clock or watch. If it is 10 p.m.,
turn the numbered timer disk clockwise until the num-
ber 22 (10 p.m.) on the disk coincides with the pointer
s (3) on the timer. Set the periods of time when you
want the appliance to work by pushing the teeth (1)
inward.
Each tooth (1) corresponds to a period of 15 minutes.
This will leave visible sectors which correspond to the
periods of operation (2). When set, the radiator will
operate automatically each day during the times pro-
grammed (important: the radiator must always be
plugged into the socket).
-
To change the programming, move the teeth back into
the initial position and set the new periods of operation.
-
To turn the appliance off completely, as well as press the
switches to the 0 position, you must also unplug it from
the power outlet to avoid continued operation of the
timer.
IMPORTANT: DO NOT ROTATE CLOCK DIAL COUNTER-
CLOCKWISE.
The timer is like an electric clock, and will only work when
plugged into a power supply. When unplugged, the timer
stops and must be later re-set.
TROUBLESHOOTING
PROBLEM
The appliance doesn't work
CAUSE
Be sure it is plugged in and that the elec-
trical outlet is working.
Check for any obstruction.
The temperature may be set too low.
Timer override (only on some models)
If you wish to override the timer settings, push the timer
switch to position I (fig.8) manual (timer override). To return
to timed operation push the switch back to the middle posi-
tion
(fig.8).
NOTE: if the timer switch is at the 0 position (fig. 8),
the heater is off and will not operate).
MAINTENANCE
Before carrying out any operation on the radiator, unplug
from the electric mains and wait for it to cool.
The oil-filled electric radiator requires no particular mainte-
nance. It is sufficient to remove the dust with a soft, dry cloth.
Never use abrasive powders or solvents. If necessary remove
concentrations of dirt using a vacuum cleaner.
TECHNICAL CHARACTERISTICS
Power supply
Absorbed power
Plug into the power outlet.
Remove the obstruction and let the appli-
ance cool down. If the appliance doesn't work
please contact Customer Experience.
Set the temperature to a higher position.
12
See rating label
"
SOLUTION
Advertisement
Table of Contents
