Table of Contents
Advertisement
can be easily reached even after installation.
-
Do not use the appliance in rooms less than 4m
area.
-
The appliance is fitted with a safety device which will
switch off it in case of accidental overheating. To reset,
please contact Customer Experience, see enclosed guar-
antee.
The appliance complies with the following EC direc-
tives:
-
Low Voltage Directive and subsequent amendments;
-
EEC Directive on electromagnetic compatibility (EMC)
and subsequent amendments;
Disposing of the appliance
The appliance must not be disposed of with house-
hold waste, but taken to an authorised waste separa-
tion and recycling centre.
INTRODUCTION
Thank you for choosing a De'Longhi product.
Please take a few minutes to read these instructions.
This will avoid all risks and damage to the appliance.
DESCRIPTION
(see figure on pag. 3).
A
Thermostat
B
Switches
C
Timer (only in certain models)
D
Cord holder
E
Wheel
USE
Electrical connection
-
Before plugging the radiator into the mains, check that
the voltage of your mains electricity supply corresponds
to the value V indicated on the appliance and that the
socket and power line are appropriately dimensioned.
-
CONNECT THE RADIATOR TO EFFICIENTLY EARTHED SOCK-
ETS ONLY.
-
This appliance complies with directive on electromag-
netic compatibility.
Fitting the feet
Remove the feet and the castors from the polystyrene pack-
ing. Insert the threaded u-bolt as shown in figures 1, 2 and
3 and use wing nuts to fix the feet to the bottom of the ra-
diator between the last two elements, then fit the castors to
the spindles on the feet and push firmly until they click into
position (fig. 4-5).
2
in
Pull each castor to check that it is fitted correctly.
In certain models, the castors are already mounted on the
feet.
Models with "Easy wheel" sytem
Turn the radiator upside-down on a rug or a soft surface in
order to prevent damaging the paint finish.
Fully unfold the castors by turning them outwards (Fig.6).
Turn the radiator back to its upright position.
Important!
When in use, the radiator should always be kept vertical
(wheels at the bottom, controls at the top). Any other posi-
tion could be dangerous!
INSTRUCTIONS FOR USE
Switching on
Turn the thermostat dial clockwise to maximum (6).
Turn on both switches. The lights on the switches remain on
until the room temperature reaches the set temperature,
then, they will switch off.
When the room reaches the required temperature, turn the
dial anticlockwise slowly until you hear a click and the lights
will switch off.
The appliance will come on and go off automatically to main-
tain the required temperature.
-
button in position «MIN» = minimum power (indicator
light on);
-
button in position «MED» = intermediate power (indi-
cator light on);
-
both buttons in position «MIN» «MED» = maximum
power (indicator lights on)
Using the thermostat
The thermostat operates on the basis of room temperature
and not radiator temperature.
Turn the thermostat dial anticlockwise towards the lower
numbers to reduce the temperature; turn it clockwise to-
wards the higher numbers to raise the temperature. To turn
the appliance off completely, turn the thermostat to mini-
mum
and unplug from the mains.
Frost protection function
With the thermostat in position
the appliance maintains the room at a temperature of about
5˚C, preventing freezing with minimum energy consump-
tion.
11
and the switches pressed,
Advertisement
Table of Contents
