Advertisement
FlavorFusion Icemaker Adaptor Kit Installation Instructions
8.
The next step is to secure the icemaker to the kit. Use the brackets (supplied) as templates to drill
four 9/64" (.140" Dia.) holes into the adapter kit (2 per side). When drilling holes, the maximum
distance from the back of the kit is 7.50 inches (refer to Figure 4). Failure to comply will result in
damage to the sliding arm mechanisms internal to the kit. Drill four holes of the same diameter into
the icemaker (2 per side). Ensure the location of the brackets will not damage the kit or the
icemaker prior to drilling any holes. USE EXTREME CAUTION NOT TO DRILL INTO ANY OTHER
COMPONENTS. Drill depths should not go further than the thickness of the material being drilled
(just enough to go through). Secure the two brackets using the screws provided.
For optimal performance, do not fill the ice bin more than 2/3 capacity (maximum fill is 4" below the top of
bin)
Publication Number: 629088673INS
DETAIL "A"
DETAIL A
FIGURE 4
- 4 -
U
© 2005-2010, IMI Cornelius Inc.
Advertisement
