Breville BES878BTR Instruction Manual page 22

CLEANING THE STEAM WAND
• The steam wand should always be cleaned
after texturing milk. Wipe the steam wand
with a damp cloth.
• After use, it is recommended to purge the
steam wand for a couple of seconds, to clear
any remaining milk. With the steam wand
positioned down over the drip tray, turn the
STEAM dial to for a couple of seconds
to allow the machine to create steam for a
couple of seconds before turning it back to
the vertical position.
• If the steam tip hole becomes blocked, it
will reduce frothing performance. Use the
provided steam wand cleaning tool to clear
the opening.
• If the steam wand is still blocked, use the
spanner in the middle of the steam wand
cleaning tool to unscrew the tip. Soak the tip
in hot water before using the cleaning tool
to unblock again. Replace the tip back on the
steam wand, using the tool.
CLEANING THE FILTER BASKETS
AND PORTAFILTER
• The filter baskets and portafilter should be
rinsed under hot water immediately after use
to remove all residual coffee oils.
• If any of the holes in the filter basket become
blocked, use the pin on the end of the
provided cleaning tool to unblock the holes.
• If the holes remain blocked, dissolve a
cleaning tablet in hot water and soak filter
basket and portafilter in solution for approx.
20 minutes. Rinse thoroughly.
CLEANING THE GROUP HEAD
• The group head interior and shower screen
should be wiped with a damp cloth after use
to remove any ground coffee particles.
• Periodically purge the machine. Place an
empty filter basket and portafilter into the
group head. Press the 1 CUP button and run
a short flow of water to rinse out any residual
coffee. Press the 1 CUP button again to stop
the hot water. Remove the portafilter and
rinse thoroughly.
22
CLEANING THE DRIP TRAY
• The drip tray should be removed, emptied
and cleaned at regular intervals, particularly
when the drip tray full indicator is
showing EMPTY ME!
• Remove the drip tray from the machine and
separate the parts. The EMPTY ME! indicator
can also be removed from the drip tray by
pulling upwards to release the side latches.
Wash all parts in warm soapy water with a
soft cloth. Rinse and dry thoroughly before
reassembling and attaching to the machine.
• The storage tray (located behind the drip
tray) can be removed and cleaned with a
soft, damp cloth.
NOTE
All parts should be cleaned by hand using
warm water and a gentle dish washing liquid.
Do not use abrasive cleansers, pads or cloths
which can scratch the surface. Do not clean any
of the parts or accessories in the dishwasher.
WARNING
Do not immerse the power cord, power plug
or appliance in water or any other liquid.
CLEANING THE OUTER HOUSING
Wipe the outer housing with a soft, damp
cloth and then polish with a soft, dry cloth.
STORING YOUR MACHINE
Before storing, press the POWER button to
turn the machine off then remove the plug
from the power outlet. Remove unused beans
from the hopper, clean the grinder (see
page 18), empty the water tank and the drip
tray. Ensure the machine is cool, clean and dry.
Place accessories in the storage tray.
Store the machine upright and do not store
anything on top.
ERROR MODE
If your machine displays
contact Breville Consumer Support.
on the LCD,