Specifications - Toro Z Master Professional 5000 Series Operator's Manual

Ignition Switch
This switch is used to start the mower engine and has three
positions: Start, Run and Off.
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Neutral Lock Position
The neutral lock position is used with the safety interlock
system to engage and to determine neutral position.
Fuel Shut-off Valve
Close the fuel shut-off valve (under the seat) when
transporting or storing the mower.
Electronic Control Unit Malfunction
Indicator Light
The electronic control unit (ECU) continuously monitors the
operation of the EFI system.
If a problem or fault within the system is detected, the
malfunction indicator light (MIL) is illuminated.
The MIL is the red light located in the right console panel.
Once the MIL illuminates, initial trouble shooting checks
should be made. Refer to Troubleshooting (page 62).
If these checks do not correct the problem, further diagnosis
and servicing by an Authorized Service Dealer is necessary.
Attachments/Accessories
A selection of Toro approved attachments and accessories is
available for use with the machine to enhance and expand
its capabilities. Contact your Authorized Service Dealer or
Distributor or go to www.Toro.com for a list of all approved
attachments and accessories.

Specifications

Note: Specifications and design are subject to change
without notice.
Width:
Without Deck
Deflector Up
Deflector Down
13
52 inch Deck
116 cm (46 inches)
146 cm (58 inches)
172 cm (68 inches)