Drive System Maintenance; Checking The Seat Belt; Checking The Tire Pressure; Checking The Wheel-Lug Nuts - Toro Z Master Revolution Series Operator's Manual

Figure 62
1. TEC power fuse (5 A)
2. 12 V accessory fuse (5 A)
3. Telematics fuse (2 A)
Figure 63
1. DC/DC module fuse (10 A)
g445889
4. TEK logic fuse (2 A)
5. TEC power fuse (5 A)
6. System fuse (7.5 A)
g445890
Drive System
Maintenance

Checking the Seat Belt

Service Interval: Before each use or daily
Inspect the seat belt for wear, cuts, and proper
operation of the retractor and buckle. Replace the
seat belt if it is damaged.

Checking the Tire Pressure

Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 83 to 97
kPa (12 to 14 psi).
Important:
Uneven tire pressure can cause an
uneven cut.
Note:
The front tires are semi-pneumatic tires and do
not require air-pressure maintenance.
Checking the Wheel-Lug
Nuts
Service Interval: After the first 100 hours—Check the
wheel-lug nuts.
Check and torque the wheel-lug nuts to 75 to 88 N∙m
(55 to 65 ft-lb).
42
Figure 64
g001055