Hints And Tips - Electrolux EN2F5842CB User Manual

Table of Contents

Advertisement

• The drum still turns at regular
intervals to prevent creases in the
laundry.
• The door stays locked.
• You must drain the water to open the
door:
1. If necessary, touch the Centrif. button
to decrease the spin speed proposed
by the appliance.
2. Press the Inicio/Pausa button:
• If you have set Rinse Hold
appliance drains the water and
spins.
• If you have set Silencioso
appliance only drains the water
The option indicator Rinse Hold
Silencioso
3. When the programme is completed
and the door locked indicator
goes off, you can open the door.
4. Press the On/Off button for a few
seconds to deactivate the appliance.
12.14 Stand-by option
The Stand-by function automatically
deactivates the appliance to reduce the
energy consumption when:

13. HINTS AND TIPS

WARNING!
Refer to Safety chapters.
13.1 The laundry load
• Divide the laundry into: white,
coloured, synthetics, delicates and
wool.
• Follow the washing instructions on the
laundry care labels.
• Do not wash white and coloured items
together.
• Some coloured items can discolour
with the first wash. We recommend
that you wash them separately for the
first couple of times.
• Turn multilayered fabrics, wool and
items with printed illustrations inside
out.
• Pre-treat stubborn stains.
• Wash stubborn stains with a special
detergent.
disappears.
• You do not use the appliance for 5
minutes .
Press the button On/Off to activate
the appliance again.
• 5 minutes after the end of the washing
programme
Press the On/Off button to activate
the appliance again.
The display shows the end of the last
programme.
Turn the programme dial to set a new
the
cycle.
If the dial is rotated to the "Reset"
position
the
turns off in 30 seconds.
If you set a programme or an
and
option that ends with water
in the drum, the Stand-by
function doesn't deactivate
the appliance to remind you
to drain the water.
• Be careful with curtains. Remove the
hooks and put the curtains in a
washing bag or pillowcase.
• A very small load can cause balance
problems with the spin phase leading
to excessive vibration. If this occurs:
a. interrupt the programme and
open the door (refer to "Daily
Use" chapter);
b. manually redistribute the load so
that the items are spaced evenly
around the tub;
c. press the Inicio/Pausa button.
The spin phase continues.
• Avoid washing garments full of long
animal hair or poor quality garments
releasing lots of fluff that could block
the drain circuit and therefore
requiring the Service assistance.
• Button up pillowcases, close zippers,
hooks and poppers. Tie up belts,
cords, shoelaces, ribbons and any
other loose elements.
ENGLISH
, the appliance automatically
25

Advertisement

Table of Contents
loading

Table of Contents