Appliance Door; Removing And Installing The Door Panels - Siemens HB513AB 1 Series Instruction Manual

Appliance door

en
Then insert the rail into the front socket
2.
rail also rests against the cooking compartment wall
here, and press it downwards
qAppliance door
W ith good care and cleaning, your appliance will retain
A p p l i a n c e d o o r
its appearance and remain fully functional for a long
time to come. This will tell you how to clean the
appliance door.

Removing and installing the door panels

To facilitate cleaning, you can remove the glass panels
from the appliance door.
Locking the appliance door
Open the appliance door fully.
1.
Open the two locking levers on the left and right
2.
(fig. ).
!
Close the appliance door as far as it goes (fig.
3.
Removing panels
Press the left- and right-hand sides of the cover
1.
(fig. ).
!
Remove the cover (fig.
2.
16
, until the
„
... (figure ).
"
).
"
Lift out each panel (fig.
3.
carefully on a flat surface.
If necessary, you can remove the condensate trough
4.
for cleaning. To do this, open the appliance door
fully (fig.
Tilt the condensate trough up and remove it (fig.
5.
Clean the panels with glass cleaner and a soft cloth.
Wipe the condensate trough with a cloth and some hot
soapy water.
:
Warning
Risk of injury!
Scratched glass in the appliance door may develop
■
).
"
into a crack. Do not use a glass scraper, sharp or
abrasive cleaning aids or detergents.
The hinges on the appliance door move when
Risk of injury!
■
opening and closing the door, and you may be
trapped. Keep your hands away from the hinges.
Fitting panels
Open the appliance door fully and refit the
1.
condensate trough. To do this, insert the trough from
above and rotate it at the bottom (fig.
) and set them down
#
).
$
).
%
).
!