Table of Contents
Advertisement
THANK YOU FOR CHOOSING ROBOTIQ
This step-by-step guide will allow you to install and test your Robotiq Palletizing Solution
on Universal Robots. Visit the
steps.
WHAT IS SUPPLIED?
1.
Standard upon delivery of
Palletizing Solution base including:
•
1 x Linear axis (1500 mm stroke)
▪
1 x Linear axis Controller
▪
4 x Pallet sensors
▪
2 x Status lights
▪
1 x Cable management system
▪
6 x Concrete anchors
•
1 x Box detection sensor
•
1 x PowerPick Vacuum Gripper kit (Optional)
•
1 x Air filter kit (optional)
•
1 x Set of four (4) casters
•
1 x Material Handling Copilot software license dongle
•
*SOL-PAL-UR-1500 does not contain the gripper, and as such the gripper installation steps do not apply.
SAFETY & WARNINGS
2.
The operator(s) must have read and understood all of the Safety section in the user manual
(available at support.robotiq.com).
The entire cell must go through a comprehensive risk assessment process before it can be used.
Do not operate the Palletizing Solution or even turn on the power supply before the device is
firmly anchored and the machine area is cleared. Make sure the air supply is secured.
Make sure to follow all safety rules and regulations of your workplace. Always wear all
recommended personal protective equipment in accordance with your workplace safety
standards.
Failure to properly secure and install the equipment can result in material damage and bodily
injury.
elearning.robotiq.com
SOL-PAL-UR-VAC-1500
to see the video of the installation
and
SOL-PAL-UR-1500*:
Advertisement
Table of Contents
Need help?
Do you have a question about the AX Series and is the answer not in the manual?