Antenna Dvb; Av Connection Settings - Loewe One User Manual

One 40
User manual
System settings
Connections

Antenna DVB

Here you can make settings for the DVB-T antenna and call the antenna
wizard for the DVB-S antenna.
Call Antenna DVB
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Connections,
go to next column.
Mark Antenna DVB,
go to next column.
... Antenna DVB Antenna
DVB-S
Antenna
DVB-T
Select the desired setting,
call.
Explanations of the setting options in the antenna DVB menu:
Antenna Here the antenna wizard starts guiding you through
DVB-S all the settings relevant to the DVB-S antenna. The
settings of the DVB-S antenna wizard are explained
in the procedure of initial installation.
Antenna Here you can set whether your DVB-T antenna needs
DVB-T a supply voltage.
Antennas with an integrated amplifier need a supply
voltage on the antenna line. In this case, select
Supply voltage 5V and confirm with OK.
Otherwise, select No supply voltage and confirm
also with OK.
Positioning/aligning DVB-T antenna
If you are receiving one or more DVB-T stations with picture and sound
interference then you should change the installation location and
alignment of the antenna. Ask your dealer to tell you which channels
are used to broadcast the DVB-T stations in your region.
A DVB-T station is received and selected.
Calling manual search (see chapter System settings, section Stations
– Manual TV/Radio scan).
Due to the preset stations, the signal source is already selected as
DVB-T. Position and align the antenna so that maximum C/N values
and levels are reached.
Search for DVB-T stations one after the other and compare values for
C/N and Level. Then position/align the antenna to the weakest station
so that maximum values for C/N and Level are obtained. The value
for BER should be as low as possible.
Thereafter, perform an automatic search for all DVB-T stations.
106
The following antenna wizard guides you through all the
necessary settings relevant to your antenna system.

AV connection settings

In the AV connection settings menu the parameters for the AV
connection socket can be adapted.
Calling the connections menu
HOME: Call Home view.
Mark System settings,
OK call System settings.
Mark Connections,
go to next column.
Mark AV connecting settings,
go to next column.
... AV connect-
ing settings
Signal type
Allow switch-
ing voltage
Select the desired setting,
call.
Explanations of setting possibilities in the AV connecting settings
menu:
Device at Indicate here whether a set and, if yes, which one is
connection connected to the AV socket.
AV
Signal type You set the signal type of the device connected to AV
here. You can find out more from your dealer.
Allow If this function is activated, the video and audio of an
switching external unit connected to the AV connector (not at
voltage AVS) will immediately be reproduced on all TV broad-
cast sites when playback is started up, provided that
the external unit supplies a switching voltage.
Please input whether a device is connected to the AV
socket and if so, which device.