Table of Contents
Advertisement
One 40
User manual
Switching the TV set ON/OFF
Switching the TV set ON/OFF
Switching TV set to the standby mode
Switch the mains switch on the bottom side of the device to position I.
The indicator on the front side lights up white. The set is now in
standby mode..
Power switch
LED display
Switching the TV set on/off via the local operating panel
To switch the TV set into operating mode or switch it
M
off into standby mode, press the joystick on the local
_
+
operating panel on the rear side of your device.
R
When pushing the joystick in the direction M/+/–, the
device switches on in the previously used mode
(TV/Radio).
When pushing the joystick in the direction R, the device
switches on in the radio mode.
Meaning of the LED colours:
white:
TV set in standby.
white, intermittent: TV set starts.
green:
TV set switched on.
red:
timer recording active.
blue:
TV set in standby and background operation
active (EPG data updating, software
update).
After switching on the TV set, it takes a few seconds for further
operating commands to be processed (Exception: Quick start
mode, see chapter System settings, section Control – Quick
start mode). Your TV set is ready for operation once the LED
display lights green.
14
M
_
+
R
Local operating panel
Switching the TV set on by means of the Remote control
Press the on/off key.
Or:
Press the TV key.
The previously watched station will be called.
Or:
Press numerical keys 1-9.
The corresponding station will be called.
After switching on the TV set, it takes a few seconds for further
operating commands to be processed (Exception: Quick Start Mode,
see below). Your TV set is ready for operation once the LED display
lights green.
Switching the set off with the remote control (Standby)
Press the on/off key.
Before switching off the set with the mains switch,
we recommend you to switch it to standby mode.
Switching off the TV set and connected additional devices
(System standby)
Press on/off key long:
Switch TV set and all CEC-capable devices connected
to the HDMI interfaces OFF to Standby mode (System
Standby).
Technical information
Switching off the TV set with the mains switch during operation or an
inadvertent disruption to the power supply (e.g. power failure) can
cause damage to the hard disk file system of an externally connected
hard disk and hence loss of the recorded broadcasts.
Before switching off the set with the mains switch, we recommend
you to switch it to standby mode.
However, if unexpected problems occur when operating the hard
disk, formatting the external hard disk may rectify this. Refer to the
instructions in chapter System settings, section Control – Hard
disks.
Loewe are not liable for the loss of data on the hard disk externally
connected to your TV set. To avoid data loss, we recommend copying
important recordings to an additional external storage medium.
Advertisement
Table of Contents
