Working Instructions - FERREX FBGS240E1 User Manual

m ATTENTION
The disk will continue to run after the equipment is switched off. There is a risk
of injury.
Test run:
Before starting work and after each change of grinding disk, carry out a test run of at
least 60 seconds with no load. Switch off the equipment immediately if the disc runs
lumpy, substantial vibrations occur, or abnormal noises are generated.

Working instructions

Grinding with the grinding disc
m ATTENTION
Fold down the spark protection (1) when grinding in order to avoid injury from
sparks.
NOTE: The arrow on the protective hood (7) shows the direction of rotation of the
grinding disc.
• Place the workpiece on the workpiece support (4) and slowly bring it to its desired
angle on the grinding disc (3).
• Move the workpiece slightly from side to side in order to achieve an optimal grind-
ing result. This way, the grinding disc is worn uniformly. Occasionally, allow the
workpiece to cool down.
Tape loops
NOTE: The arrow on the protective hood (16) shows the direction of rotation of the
grinding belt.
• Firmly hold the workpiece, do not exert any strong force.
• Move the workpiece slightly from side to side in order to avoid a one-sided wear of
the grinding belt.
• Always grind the pieces of wood in the direction of the wood grain in order to avoid
chipping.
Change grinding belt (Fig. 6)
• Loosen the 2 fixing screws (11) and hang out the grinding belt cover (12).
• Press the clamping lever (18) downwards and detract the grinding belt (19).
• Place the new grinding belt (19) in the centre on the upper (10a) and lower (10b)
rollers.
• Push the clamping lever grinding belt (18) and mount the grinding belt cover (12).
Operation/Working instructions Kapitelüberschrift
17