Assembly - FERREX FBGS240E1 User Manual

Assembly

m WARNING
Always pull out the mains plug before carrying out adjustments on the device.
Spark protection assemble/set (Fig. 2)
• Screw the spark protection (1) using the adjusting screw (2) and the nut on to the
protective hood (7). To do so you will need a screwdriver and a ring spanner (AF 8
mm / not included), used to hold it in place.
• Set the spark protection (1) with the adjusting screw (2) so that the distance be-
tween the grinding disc (3) and the spark protection is max. 2 mm (see small im-
age).
m ATTENTION
Periodically readjust the spark protection in order to offset the wear and tear
of the grinding disc and the spark protection is max. 2 mm.
Workpiece supports assemble / set (Fig. 3+4)
• Screw the workpiece supports (4/13) on to the device. Two positions are possible for
the tape loop (see fig. 3 / Pos. A + B).
• To do so, use the screws (5/14), washers, toothed lock washer and star grip nuts
provided.
• Set the workpiece support of the grinding belt (4) with the star grip nut (5) so that
the distance between the grinding disc (3) and the workpiece support is max. 2 mm
(see small image).
m ATTENTION
Periodically readjust the spark protection in order to offset the wear and tear
of the grinding disc and the spark protection is max. 2mm.
Screw device on to workbench (Fig. 5)
• Screw the device onto the workbench with 4 screws and nuts. Insert the screws
through the 4 bore holes (15) on the base of the device. The screws and nuts re-
quired for assembly are not part of the scope of delivery.
Safety regulations/Assembly Kapitelüberschrift
15