Operation - FERREX FBGS240E1 User Manual

Operation

Kapitelüberschrift
Operation
m ATTENTION
- Always make sure the device is fully assembled before commissioning!
- Always disconnect the plug from the mains socket before working.
- Use only grinding disks and accessories recommended by the manufacturer.
The use of other insertion tools and other accessories may cause risk of injury.
- Only use grinding tools which bear information about the manufacturer, type of
binding, dimension and permitted number of revolutions.
- Only use grinding discs where the printed rotational speed is at least as high as
what has been specified on the name plate of the device.
- Do not use broken, cracked or other-wise damaged grinding disks.
- Never operate the device without the visual protection disk.
- Always use protective goggles even if you are protected against sparks.
- Always inspect the grinding disc before starting the device: Check the distance
between the spark protection and grinding disc as well as workpiece support
and grinding disc (distance maximum 2 mm).
- The grinding disc must be replaced once the spark protection and workpiece
support on the grinding disc do not have distance of max. 2 mm.
- Switch on the equipment only whenit is safely installed on the work surface.
m ATTENTION
Keep your hands away from the grinding disc and grinding belt when the de-
vice is in operation. Injury hazard!
m ATTENTION! It is recommended that the tool always be supplied via a residual
current device having a rated residual current of 30mA or less.
Switching on and off
• To switch on, press the "I" on switch (8) and the device starts up and the working
light begins to shine.
• To switch off, press the "0" off switch (8) and the device switches off and the work-
ing light goes out as a result.
After switching on the device, wait until the device has reached its max. speed. Only
then must you start the grinding.
16