Troubleshooting - Zanussi ZFC26500WA User Manual

Periods of non-operation
When the appliance is not in use for long
periods, take the following precautions:
1. Switch off the appliance and disconnect the
appliance from electricity supply.
2. Remove all food

Troubleshooting

WARNING!
Refer to Safety chapters.
What to do if...
Problem
The appliance does not operate.
The appliance is noisy.
The lid doesn't close completely.
The lid is difficult to open.
The lamp does not work.
The compressor operates contin-
ually.
8
3. Defrost and clean the appliance and all
4. Leave the lid open to prevent unpleasant
Possible cause
The appliance is switched off.
The mains plug is not connected
to the mains socket correctly.
There is no voltage in the mains
socket.
The appliance is not supported
properly.
Food packages are blocking the
lid.
There is excessive frost.
The lid gaskets are dirty or sticky. Clean the lid gaskets.
The valve is blocked.
The lamp is defective.
Temperature is set incorrectly.
Large quantities of food to be
frozen were put in at the same
time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
accessories.
smells.
If the cabinet will be kept on, ask
somebody to check it once in a
while to prevent the food inside from
spoiling in case of a power failure.
Switch on the appliance.
Connect the mains plug to the
mains socket correctly.
Connect to a different electrical
mains socket. Contact a qualified
electrician.
Check if the appliance stands
stable.
Arrange the packages in the right
way, see the sticker in the appli-
ance.
Eliminate excess frost.
Check the valve.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food to cool to room tem-
perature before storing.
Solution
www.zanussi.com