Sealey CST800.V2 Quick Start Manual

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Refer to
instructions
1. SAFETY
Always load evenly with the centre of gravity of the load as near the centre and rear of the plate as possible.
9
Obtain additional support for large or wide loads to prevent tipping.
9
DO NOT overload the truck - see Specification.
8
DO NOT leave unattended, especially when loaded, unless the wheels are chocked or the truck is otherwise secured.
8
DO NOT use truck on uneven ground and do not run over curbs or steps - use a ramp.
8
DO NOT allow others to ride on the truck.
8
DO NOT use the truck if any part is damaged, paying particular attention to the wheels.
8
2. INTRODUCTION
Manufactured from strong tubular steel with heavy-duty pneumatic tyres for transportation over rough terrain. Features foldaway toe plate
providing increased loading area. Ideal for delivery drivers, farmers or builders.
3. SPECIFICATION
Model No. .............................................................. CST800.V2
Capacity ..........................................................................150kg
Wheel Size .................................................................Ø250mm
Wheel Width ....................................................................90mm
Height ..........................................................................1140mm
Overall Width .................................................................490mm
Platform Depth .........................................................90/420mm
4. ASSEMBLY
4.1. WHEELS
4.1.1. Ensure each axle is clean from dust and dirt to allow free movement of the
wheel.
4.1.2. Slide the wheel (fig.1.2) onto the axle (fig.1.1), followed by the washer (fig.1.3)
and complete by pushing the split pin (fig.1.4) through the hole in the end of the
axle and bending over to retain.
4.1.3. Repeat for the other side.
4.2. TOE PLATE
4.2.1. If the toe plate is not already attached, do so using the bolts, washers and nuts
supplied.
4.2.2. Attach at the bottom of the truck as in Fig.2.1
5. OPERATION
5.1. Check and inflate the tyres. DO NOT inflate above 30psi.
5.2. Fold down the toe plate ready to accept a load. (See fig.2)
DO NOT overload the sack truck. DO NOT try to carry loads that make the truck
8
unstable.
5.3. Slowly lean the sack truck backwards to take the weight of the load.
5.4. Proceed at a safe speed especially at corners where there could be a danger of the
load shifting.
5.5.
Extra care should be taken on inclined surfaces.
5.6. Where there is a curb or step, a ramp should be used.
5.7.
After use fold up the toe plate and store in a safe dry place.
5.8. Periodically check all fittings are tight and the wheel split pins are secure.
© Jack Sealey Limited
150KG FOLDABLE TOE SACK TRUCK WITH
PNEUMATIC TYRES
CST800.V2
MODEL NO:
Original Language Version
fig.1
fig.2
CST800.V2 Issue 1 22/07/19