NEC PlasmaSync PX-42VM1G Service Manual page 90

METHOD OF ADJUSTMENTS
EDID data writing for the PC3 (DV1) input
7-6. Data writing
(1) Short-circuit the section between TP7003 and TP7004. (For writing ready)
(2) Using a writing jig, enter inputs of clock (DDC CLOCK) from Pin 6 of the RGB3 input terminal (M7201)
and data (DDC DATA) from Pin 7 according to the specified writing sequence, and write the data of
Table 5-2 in IC7201.
7-7. DDC2B check
(1) Using a reading jig, take outputs of clock (DDC CLOCK) from Pin 6 of the RGB3 input terminal
(M7201) and data (DDC DATA) from Pin 7 according to the specified reading sequence, and confirm
that the data of Table 7-2 are output from Pin 7 .
(2) Remove the short-circuit condition from the section between TP7003 and TP7004.
0
00 00
10 06
20 17
30 01
40 68
50 0F
60 78
70 00
8. End setting and confirmation
Remove the short-circuit condition from the section between TP9701 and TP9702.
5-12
Table 7-2 EDID Data
1 2 3 4 5
FF FF FF FF FF FF
0A 01 02 88 5C
42 4E AF CE 00
01 01 01 01 01
00 98 06 32 00
60 62 00 B3 06
18 50 0B 00 0A
50 58 2D 34 32
6 7 8 9 A
00 38 A3 77
34 78 28 00 E5 A0 5A
81 80 4B C0 01
2F 0D 50 F0 30
00 18 D6 09 80
22 00 00 1E 00
20 20 20 20 20
56 4D 31 0A 20
B C D E F
A4 00 00 00 00
27 BA 25
01 01 01 01 01
E0 25 10 10 70
A0 20 E0 2D 10
00 00 FD 00 32
20 00 00 00 FC
20 20 20 00 14