Installation And Electrical Installation; Installation - Scholl 26060 FB/4 Instructions For Use Manual

GBA C 2100 3 E
4 I
NSTALLATION AND ELECTRICAL INSTALLATION
4.1 I
NSTALLATION
Before the installation of the appliance, observe the following:
 Inspect the unit for any defect or damage sustained in transit.
 Check all screw connections for tightness.
 Familiarize yourself with the Instructions for Use and with the conditions for the safe operation of this
appliance.
Practice:
 Place the hot plate at a suitable location.
 Prepare cut-out for hot plate in on site worktop.
 Prepare cut-out for thermostat built-in casing in on site counter top.
 Remove the toggle from the thermostat built-in casing and screw off the front cover.
 Guide the thermostat built-in casing through the cut-out opening from behind.
 Screw the front cover to the thermostat built-in casing again and push on the toggle.
 Attach the front cover to the on site counter cover.
 Attach the hot plate from above in the workplace section.
 Seal the hot plate edge.
 Clean the hot plate before the first use according to chapter "Cleaning and care".
BA
Last revised 05-2020
Page 12 of 25 Mai 20, 2020
Rev. 3