Installation And Electrical Installation; Installation - Scholl 26060/FB/DIG Instructions For Use Manual

GBA C 5110 2 E
4 I
NSTALLATION AND ELECTRICAL INSTALLATION
4.1 I
NSTALLATION
Before the installation of the appliance, observe the following:
 Inspect the unit for any defect or damage sustained in transit.
 Check all screw connections for tightness.
 Familiarize yourself with the Instructions for Use and with the conditions for the safe operation of this
appliance.
Practice:
 Place the hot plate at a suitable location.
 Prepare cut-out for hot plate in on site worktop.
 Prepare cut-out for temperature controller built-in casing in on site counter top.
 Screw off the front cover from the temperature controller built-in casing.
 Guide the temperature controller built-in casing through the cut-out opening from behind.
 Screw the front cover to the temperature controller built-in casing again.
 Attach the front cover to the on site counter cover.
 Attach the hot plate from above in the workplace section.
 Seal the hot plate edge.
 Clean the unit before the first use according to chapter "Cleaning and care".
BA
Last revised 03-2021
Page 11 of 24 März 17, 2021
Rev. 2