Table of Contents
Advertisement
Control
7.2.2 Operation
Status messages
After the thermostat has been switched on, the PV and SV displays jointly show a set sequence of
three status messages before they change to the normal view where the current process value is
shown on the PV display and the currently set temperature value is shown on the SV display.
Changing the set temperature value
To change the set temperature value, perform the following steps:
1. During operation, press the
7
2. Change the set value as required, using the
3. Confirm the setting by pressing the
i
Important
The set temperature value, which is adjustable by the above procedure, can be used in different
ways and with different functions depending on how the thermostat is used in the individual
application.
For further information see →
102
Control voltage switched on
PV
UEr
SV
PV
SV
PV
SV
S S E E T T
TR-16e
1 x briefly
The SV display is blinking.
S S E E T T
TR-16e
The SV display shows the desired temperature value.
S S E E T T
TR-16e
1 x briefly
The SV display permanently shows the new set value.
1.
Software version view (factory setting)
2.
Input specification view (factory setting)
3.
Measuring range (factory setting)
PV = lower limit
SV = upper limit
4.
The two displays finally change to normal view:
Normal view
PV = currently measured temperature (process value)
SV = currently set temperature value
S S E E T T
button.
,
S S E E T T
button.
7.2.3 Initial Settings, p.
107.
and
buttons.
AHU Kit – Installation Instructions – 11/2021
Advertisement
Table of Contents
