Draining Residual Water - Hisense WFER1014VA User's Operation Manual

Table of Contents

Advertisement

Select the "Rinse+Spin" programme,reduce the speed to 1000rpm and strat
Powder detergent compartment(Middle)
Powder detergent compartment(Middle)

DRAINING RESIDUAL WATER

Before emptying the residual water, switch the appliance off and unplug it
fromthe mains socket. Remove the plinth,place a container beneath it.
1 Pull out emergency drain pipe of machine.
2 Put end of emergency drain pipe into a container.
3 Rotate emergency drain pipe plug and remove it after it becomes loose.
4 Until water runs off naturally.
5 Reinstall emergency drain pipe plug.
6 Fill detergent box with 1L water to check
emergency drain pipe.Check if there is
any leakage at connection of pipe plug.
7 Put emergency drain pipe back.
10
unds
Powder detergent compartment(Middle)
(depends on model)
1. While holding down the release lever on the inner
of the drawer, slide open the drawer and remove
it from the machine.
Open the lids of both compartments, add water
2.
and shake to loosen/remove soap residue.
Repeat until clear.
Clean the cap valves of both compartments with a
3.
soft brush.
4. Clean the drawer components under running
water using a soft brush.
5. Clean the drawer recess within the machine using
a soft brush. Make sure to clean the cap valves to
prevent clogging.
6. Once cleaning is complete, slide the drawer back
into position ensuring it moves freely into its fully
retracted position.
We recommend that you check and clean the filter regularly, at least two or three
times a year.
Ensure that the water has
1
2
Insert removal tool like slotted screwdriver into the small opening of bottom
baffle, press the bottom baffle downward with much strength and open it.
if it fails to perform spin cycles.
11

Advertisement

Table of Contents
loading

Table of Contents