homelabs HME021001N Manual page 12

Operation
CONTROL PANEL
HME021004N)
Press to activate the "Pump" operation.
NOTE:
Before starting Pump, make sure the
Pump Drain Hose is attached, the
continuous Drain Hose is removed and the
plastic cover of the Continuous Drain Hose
Outlet is replaced tightly. When the Bucket
to the next pages for removing
the collected water.
NOTE:
It needs time before water was pumped
at the beginning.
Press this button to turn the comfort function
"On/Off". Under this mode, the humidity cannot
be adjusted manually but will be preset to a
recommended comfortable level based on the
ambient temperature. The level will be
controlledas per below table:
Ambient <65°F
Humidity
NOTE:
Press or button, the "Comfort"
mode will be canceled, and the humidity
level can be adjusted.
65–77°F >77°F
55% 50% 45%
Controls the fan speed. Press to select
either "High" or "Normal" fan speed. Set
the fan control to "High" for maximum
moisture removal When the humidity has
been reduced and quiet operation is
preferred, set the fan control to "Normal".
Press to set an "Auto On" or an "Auto Off" timer
(0–24 hours) in conjunction with the
buttons. The timer runs only one cycle, thus
remember to set a timer before next time's use.
• After plugging in the appliance, press "Timer"
button, the "Timer Off" indicator will light up,
meaning the "Auto Off" timer setting is activated.
Use and
want to shut down the appliance. The one-off "Auto
• Press "Timer" button again, the "Timer On" indicator
will light up, meaning the "Auto On" timer setting is
activated. Use
time you want to turn on the appliance next time.
• To change the timer settings, repeat the above
operations.
• Press or hold
Time" by 0.5 hour increments, up to 10 hours, then
at 1 hour increments up to 24 hours. The control will
count down the time remaining until start.
• The selected time will register in 5 seconds and the
system will automatically revert back to display the
previous humidity setting.
• To cancel a "Timer", adjust the "Timer" value to
0.0. The corresponding timer indicator will light
off, meaning the timer is canceled. Another way
to cancel a "Timer" is restart the appliance, the
one-off timer will also become invalid.
• When the Bucket is full, the screen displays "P2"
error code, the appliance will then shut down
automatically. Both the "Auto On" / "Auto Off"
timer will be canceled.
12
and
buttons to set the value of time you
and buttons to set the value of
and buttons to change the "Auto