Sherwood NewCastle R-945 User Manual page 15

Adjusting the speaker settings
Adjusting the settings of the center speaker, rear
speakers and subwoofer connected.
Press the SPEAKER MODE button for more than 2
seconds to enter the center speaker mode.
2
In THEATER, HALL, STADIUM, CHURCH or
normal stereo mode, it will enter the subwoofer mode
directly.
Select the desired center speaker mode.
3
Each time this button is pressed, the center speaker
mode changes and flickers as follows;
:When using a relatively large center speaker.
LARGE
:When using a relatively small center speaker.
SMALL
:When not using a center speaker.
NONE
In the DTS mode or the Dolby 3 Stereo mode,
the NONE mode can not be selected. (For details, refer
to"SURROUND SOUND" on page 14.)
Memorize the desired center speaker mode
while it flickers.
4
The desired center speaker mode is memorized and
then it enters the rear speaker mode in the Dolby
Digital(AC-3) mode.
In normal stereo mode and other surround modes
except for Dolby Digital(AC-3) mode, it enters the
subwoofer mode directly.
If the center speaker display goes off, repeat again
from the above step 2.
Select the desired rear speaker mode.
5
Each time this button is pressed,the rear speaker
mode changes and flickers as follows;
YES : When using the rear speakers.
NO : When not using the rear speakers.
Memorize the desired rear speaker mode
while it flickers.
6
The desired rear speaker mode is memorized and
then it enters the subwoofer mode.
If the rear speaker display goes off, repeat again
from the above step 2.
Select the desired subwoofer mode.
7
Each time this button is pressed,the subwoofer
mode changes and flickers as follows;
YES : When using a subwoofer.
NO : When not using a subwoofer.
16