Rowlinson Garden Products SS317A Assembly Instructions

6. Lids

To each lid fit a lid front board using 2 x 35mm screws. Screw through the front board into the lid rails. Determine
which lid is which as described below, Position the lids in place. Align the pre-drilled bolt holes and insert a bolts. Using
the 100mm bolts in the end panels and the 150mm bolts in the dividing panels. Secure each bolt with a washer and a
nut. Do not over tighten the nuts. Attach two chains to the inside of each lid using 1 x 12 mm screw per chain. Position
the chains so that they can be looped round the handles of the bin and hooked back on the chain. Attach the lid stays
using 1 x 40mm screws per stay as shown.
Important Note: To determine which roof panel is which, look at the front
edge of each lid, the overhang of the cladding at each side is different.
View of the front edges of the three lids
Left Lid Centre Lid
Large Small
overhang overhang overhang
40mm
12mm
100mm
Nut
Washer
Right Lid
Small Large
overhang
Lid rails
Drill
Nut
150mm
Washer

Using the bin store

Position the bin inside
the store, loop the
chains around the
handles of the bin and
attach the S hook to
one of the chain links.
Triple Bin Store
Assembly Instructions

Before assembly

•
We recommend that time is taken to
read the instructions before starting
assembly, then follow the easy step
by step guide. The instruction sheet
is only a guide to the assembly.
Certain items may not be shown to scale.
•
Check all components prior to assembly
•
This product should be assembled
by no less than two people.
•
Never attempt to erect the assembly
in high winds.
Important: •
Drill pilot holes for each screw
Drill pilot holes in the
lid front boards for
each screw to avoid
splitting the timber.
x 2
Drill
Recommended tools for assembly
•
Power drill/screwdriver
35mm
•
Cross head screwdriver bit
• 3mm drill bit
• 13mm spanner
No. Components
1 Base plate
2 End panel
3 Dividing panel
4 Back panels
5 Door
6 Left lid
7 Centre lid
100mm
8 Right lid
9 Lid front board
10 Lid stay
11 Centre front rail
12 Left/right front rail
No. Fixing kit
13 Hinges
14 Slide bolt
15 150mm bolt
16 100mm bolt
17 Nuts
18 Washers
19 Chain
20 60mm screws
21 40mm screws
22 35mm screws
23 30mm screws
24 12mm screws
English SS317A
Biocidal Products Regulation EU 528/2012
Wolmanit CX treated wood is a treated article that incorporates biocidal products: cop-
®
per hydroxide carbonate/II/ and boric acid. They protect wood against fungal decay /rot/
and insect attack. Keep away from food, drink and animal feeding stuffs. Avoid breathing
dust when cutting treated wood.
Qty.
6
2
2
3
3
6
1
7
1
1 13
3
3
1
14
10
2
.
Qty
4
6
3
2
2
4
4
11
6
18 5
23
6
1
54
6
8
9
3
12
2