Advertisement
First Screen displayed after pushing Configure?
Use Speaker with
Subwoofer? Yes or No
If subwoofer = No: then go to location screen
No is the default selection.
If subwoofer = Yes then: Subwoofer selection screen
Subwoofer used:
Selections
SP Subwoofer
Other Sub 100 Hz
Other Sub 110 Hz
Other Sub 120 Hz
NOTE: The rotary knob must be used to scroll down to see all the choices.
If SP Subwoofer
Connect Mixer to
Sub Input
Connect Sub Proc
Out to Input
Speaker Proc Out
is Muted
With the mixer output (sound source) connected to the subwoofer, all of the system adjustments will be made
using the SP Sub DSP module. The User processing choices in the SP®2P, such as the 9 band GEQ, will be by-
passed, the delay will be bypassed, and the processed output muted. Program EQ (presets), GEQ and delay
screens are all affected. The hi-pass filter on the SP®2P woofer is unchanged from it's full range setting, because
the Sub performs the crossover functions.
If Other Subwoofer
Connect Mixer to
Speaker Input
Connect Proc
Out to Sub Input
When the Sub is selected, the program EQ (presets), GEQ and delay screens function normally. The Processed
output sends a subwoofer signal out the processed output. The Hi-pass filter on the SP®2P woofer is raised to
cross-over with the subwoofer processed output at the selected frequency.
Speaker Location: (configuration submenu)
This affects some of the dedicated processing of the woofer to account for boundary surfaces etc.
Pole Mount (Default Selection)
Flown
Advertisement
