Gallagher T12 Manual page 8

An HBUS Reader connects to a Gallagher Controller 6000, Gallagher 4H/8H Module (a ached to
a Controller 6000) or a Gallagher HBUS Door Module (connected to a Controller 6000).
A Cardax IV Reader connects to a Gallagher Controller 6000, Gallagher 4R/8R Module (a ached
to a Controller 6000) or a Gallagher GBUS Universal Reader Interface (Gallagher GBUS URI).
HBUS Reader connec on:
Note: To terminate an HBUS Reader, connect the Orange (HBUS Termina on) wire to the Green
(HBUS A) wire.
Cardax IV Reader connec on:
5. Fit the facia assembly into the bezel by clipping the small lip, into the top of the bezel and holding
the top, press the bo om of the facia assembly down into the bezel.
6. Insert the M3 Torx Post Security screw (using a T10 Torx Post Security screwdriver) through the
hole at the bo om of the bezel to secure the facia assembly.
Note: The Torx Post Security screw needs only to be lightly ghtened.
7. Removal of the facia assembly is a simple reversal of these steps.
8. Confi gure the reader in Command Centre. If the reader is connected as an HBUS Reader, refer to
the topic "Confi guring HBUS Devices" in the Command Centre Confi gura on Client Online Help.
If the reader is connected as a Cardax IV Reader, refer to the topic "Crea ng Readers" in the
Command Centre Confi gura on Client Online Help.
3E4720 Gallagher T12 Reader | Edi on 12 | May 2023
Copyright © Gallagher Group Limited
Posi ve Red
Nega ve Black
HBUS Termina on Orange
HBUS A Green
HBUS B Brown
CDXIV TX White
CDXIV RX Blue
Posi ve Red
Nega ve Black
HBUS Termina on Orange
HBUS A Green
HBUS B Brown
CDXIV TX White
CDXIV RX Blue
Facia
Reader tail
Fit screw to secure facia to bezel
HBUS Reader terminated:
Posi ve
Nega ve
HBUS Termina on Orange
HBUS A
HBUS B
CDXIV TX
CDXIV RX
Building cable
Connec on
Red
Black
Green
Brown
White
Blue
Bezel
Page 8