Section Ii: Startup & Operation; Initial Cleaning; Removing & Cleaning The Draw-Off Valve - AccuTemp EDGE ALTLGB Owner's Manual And Installation Instructions

Section II: Startup & Operation
Warning:
Always disconnect power before cleaning (or servicing)
the unit.
The control console is not waterproof. Never spray the
control console, electrical controls, ignition system
controls, or connections with water. Clean these areas by
wiping them with a clean, damp cloth.
When cooking, never allow water or foodstuff to come in
contact with any electrical components.

Initial Cleaning

Before operating your equipment, it must be cleaned
thoroughly. Refer to section IV: Caring for Stainless Steel
for instructions.
Important! Disconnect all electrical power before
cleaning the unit.
Clean the unit thoroughly with a mild detergent
solution. Always "wipe"
around the control
console (never spray).
Never rinse control
consoles with a spray
hose or let water come
in contact with any
electrical and control
components.
For routine cleaning,
Accutemp's optional
"Care Kit" accessories
help you thoroughly
clean all surfaces,
including the inside of
the lid and the inside
of the draw-off valve.
During washing, excess
water in the kettle may be drained away through the
draw-off using the optional drain hose attachment.
Use the "Care Kit" to clean hard to reach places like inside
the lid and inside the draw-off valve. Rinse and drain
away wastewater easily through the optional drain hose.
Take care when removing the draw-off valve for
cleaning. The draw-off hex bonnet nut and valve stem
are surprisingly heavy. Do not drop them, since this can
cause damage to the stem creating leaks. Also be sure
to remove all water from the kettle before removing the
draw-off valve.
Removing & Cleaning the Draw-Off Valve:
1.
Make sure the stem is in the open position.
2. Unscrew the hex bonnet nut.
3. Carefully remove the nut and stem assembly
8