Troubleshooting - AEG L9WS99OKO User Manual

42 www.aeg.com
WARNING!
Make sure that the temperature is more than 5 °C and the water is flowing
from the tap before you use the appliance again.
The manufacturer is not responsible for damages caused by low
temperatures.

16. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
16.1 Introduction
The start of the appliance does not occur or it stops during operation.
First try to find a solution to the problem (refer to the table). If not, contact the Authorised
Service Centre.
CAUTION!
Deactivate the appliance before you do the checks.
With some problems, the acoustic signals operate and the display shows an alarm
message.
16.2 Possible failures
Problems with alarm messages
Message
The display tells to check the
tap: the appliance does not
fill with water.
The display tells to check the
drain filter: the appliance
does not drain the water.
Possible solution
Make sure that the water tap is open.
Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authori-
ty.
Make sure that the water tap is not clogged or is furred
with lime-scale.
Make sure that the filter of the inlet hose and the filter of
the valve are not clogged. Refer to "Care and cleaning".
Make sure that the inlet hose is not damaged.
Make sure that the connection of the water inlet hose is
correct.
Make sure that the drain hose is not damaged.
Make sure that the drain filter is not clogged. Clean the
filter, if necessary. Refer to 'Care and cleaning'.