Remote Control; Ac Power Connection - Sharp SD-HX500 Operation Manual

Remote control

! Battery installation
1 Open the battery cover.
2 Insert the supplied batteries
according to the direction in-
dicated in the battery com-
partment.
When inserting or removing the bat-
teries, push them toward the bat-
tery terminals.
3 Close the cover.
Precautions for battery use:
" Replace all old batteries with new ones at the same time.
" Do not mix old and new batteries.
" Remove the batteries if the unit will not be used for long periods of time. This will
prevent potential damage due to battery leakage.
Caution:
" Do not use rechargeable batteries (nickel-cadmium battery, etc.).
" Installing the batteries incorrectly may cause the unit to malfunction.
Notes concerning use:
" Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
" Periodically clean the transmitter on the remote control and the sensor on the unit
with a soft cloth.
" Exposing the sensor on the unit to strong light may interfere with operation.
Change the lighting or the direction of the unit.
" Keep the remote control away from moisture, heat, shock, and vibrations.
! Test of the remote control
Point the remote control directly at the re-
mote sensor on the main unit.
The remote control can be used
within the range shown on the
right.
Press the ON/STAND-BY button. Does
the power turn on? Now, you can enjoy
your system.
Note:
The remote control may not work while the
disc door is open. Move closer to the main
unit, or aim the remote control from differ-
ent angles.

AC power connection

! Connecting the AC power cord
After checking all the connections have been made correctly, plug the AC power cord
of this unit into the AC outlet.
Note:
Unplug the AC power cord from the AC outlet if the unit will not be in use for a pro-
longed period of time.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT.
! To turn the power on
Press the ON/STAND-BY button.
If the power does not turn on, check if the power cords are plugged in properly.
To set the unit to stand-by mode:
Press the ON/STAND-BY button again.
Notes:
" After the unit enters the power stand-by mode, wait a few seconds to turn on
Main unit
" You can also use the ON/STAND-BY button on the remote control.
Remote
sensor
8" - 20'
(0.2 m - 6 m)
AC outlet
(AC 120 V, 60 Hz)
again.
Main unit
SD-HX500
ENGLISH
E-16