Table of Contents
Advertisement
Installation
– Fan Body, Wiring Harness, Canopy Cover, and Blades
2a
A
B
1
NOTICE
To prevent damage to fan, ALWAYS lift holding either the
fan housing or the downrod.
Install snap-on canopy (B) over downrod on fan body (C). Place the down
rod ball into the slot in canopy mount (A) with built-in ceiling bracket.
2c
B
Slide the snap-on canopy (B)
over the canopy mount (A) until
it clicks in place.
2b
B
C
Connect wiring harness from canopy mount (A) to wiring harness
from fan body (C).
2d
Note: Follow the instructions on the blade.
Installing it incorrectly could result in your
fan not functioning.
Install a snap-on blade to pop locks on pre-installed blade iron.
Repeat for remaining blades (E).
B
IMPORTANT
Note: For single switch wiring an additional
jumper harness component will be needed.
Take the jumper harness (H) from the
accessories bag. Connect the female end
C
to the hanging bracket connector. Connect
the male end of the jumper harness to the
ceiling fan connector.
E
D
x5
C
IMPORTANT
A
H
2
7
Advertisement
Table of Contents
