Nexgrill DELUXE 730-0896CA Operating Instruction page 13

3. Use a 6 mm socket and wrench or 6 mm nut driver to
remove the brass orifice from the end of gas valve.
Replace with the Natural gas orifice.
IMPORTANT: Check that the orifice is properly
installed inside of the burner opening.
4. Reinsert the burner and reattach using the cotter pin
previously removed. Repeat the procedure for each main
burner.
!
5. Position the igniters so they are 3.2 mm / 1/8 in.away
from each burner.
Change the Sear Burner Orifice
1. Use a screwdriver to remove screw from the iginitor pin.
2. Remove two screws on the rear of the searing burner.
Lift the burner starting from the back.
3. Use 6 mm socket wrench or 6 mm nut driver to remove
the orifice. Replace with the Natural gas orifice.
IMPORTANT: Check that the orifice is properly
installed inside of the valve.
4. Reinstall sear burner.
!
5. Tighten the two screws on the rear of the sear burner.
6. Reinstall the ignitor pin.
13