Blaupunkt AHS801 Instruction Manual page 8

AHS801
1. Body
2. Water tank
3. Display with control panel
4. Filter with valve
5. Water-mist outlet
USING THE AIR HUMIDIFIER
1. Remove the water tank (2) from the device body (1), unscrew the filter valve (4), and fill the tank (2)
with water. Tighten the water tank (2) along with the filter (4). Place the water tank (2) in the body of
the device (1).
2. Make sure the water-mist-outlet nozzle (5) is well seated in the appliance.
3. Connect the appliance to a suitable power source. The display lights up for a moment, then turns off,
and the device goes into standby mode.
WARNING: When the water tank is empty, the "empty water tank" indicator will appear on the display
and the humidifier will stop working. Fill the water tank to continue operation.
BUTTON DESCRIPTIONS
Switch: When the push-button is pressed, the humidifier will emit a water mist and the operating
parameters can be checked on the LED display. Press this button again to return to standby mode.
Humidification intensity:
pressing this button.
Night mode: Press this button to start the night mode; the display turns off, and the humidifier
goes into automatic mode.
Warning: A long press of the button (3 seconds) will turn off the sounds associated with pressing the
function keys. To restore the sounds, hold the button down again.
Humidistat / AUTO mode:
press changes the target moisture value from 40% to 80% RH. The humidifier will start and stop the
humidification of air oscillating around the selected air humidity. When the humidistat mode is
started, the humidifier will operate for the first two minutes, regardless of the ambient humidity.
A long press of the button (3 seconds) will start the automatic mode. The automatic mode will
maintain a humidity of 55% ~ 68% by adjusting the humidification intensity to the ambient conditions.
Negative ions: Short press of button: Turns on/off the negative ion generator. Long press of the
button: Turn off the humidification process, keep the fan running for purification process.
Timer / UV lamp: A short press of the button launches the timer; each press sets the time to turn off
the device from 1 to 10 hours.A long press of the button (3 seconds) turns on or off the internal UV
lamp for air sterilisation.
Hot mist: Pressing the button starts the water-mist heating. To turn off the water-mist heating,
press the button again. Longer press 2 secs to reset the 72 hours clean mode.
THE LED DISPLAY
When the "%" symbol lights up, the display shows the relative humidity of the air.
When the "℃" symbol lights up, the display shows the current ambient temperature.
The humidification intensity can be adjusted in three steps by
A short press of the button activates the constant-humidity mode. Each
6. Aromatherapy attachment
7. Air-filter cover
8. HEPA H13 air filter
6