Lindy CAT-16 IP User Manual page 27

Section 5
Enable Dynamic DNS
Enables the Dynamic DNS service. This requires a configured DNS server IP address.
Dynamic DNS server
This is the server name where the CAT-32 IP registers itself in regular intervals. At the time of
writing, this is a fixed setting since only dyndns.org is currently supported.
Hostname
This is the hostname of the CAT-32 IP that is provided by the Dynamic DNS Server. (Use the
whole name including the domain, e.g. testserver.dyndns.org not just the actual hostname).
Username
You have registered this username during your manual registration with the Dynamic DNS
Server. Spaces are not allowed in the nickname.
Password
The password used during manual registration with the Dynamic DNS Server.
Check time
The CAT-32 IP registers itself in the Dynamic DNS server at this time.
Check interval
This is the interval for reporting again to the Dynamic DNS server by the CAT-32 IP.
Note: The KVM over IP module has its own independent real time clock. Make sure the time
setting is correct. (See the Section called Date and Time on page 59)
IP Access Configuration & Operation
52
Section 5
Security
Force HTTPS
If this option is enabled, access to the web front-end is only possible using an HTTPS
connection. The CAT-32 IP will not listen on the HTTP port for incoming connections.
KVM encryption
This option controls the encryption of the RFB protocol. RFB is used by the Remote Console to
transmit both the screen data to the administrator's machine and the keyboard and mouse data
back to the host. If set to "Off" no encryption will be used. If set to "Try", the applet will attempt
to establish an encrypted connection. If connection establishment fails for any reason an
unencrypted connection will be used. If set to Force the applet tries to make an encrypted
connection. An error will be reported if connection establishment fails.
IP Access Configuration & Operation
53